How to: Replace a second IDE hard drive.
Solution:
Backup all files and remove cover. Set jumpers and drive selection switches on new hard disk, install drive in bay and reconnect cables. Turn on computer, run setup, partition disk and format each logical drive.
WARNING: Electrical shock hazard! Make sure the power is turned off and the external power cables have been disconnected before removing the computer cover.
CAUTION 1: This task should be performed by a qualified computer technician.
CAUTION 2: Please observe steps to reduce the potential damage to computer components from electrostatic discharge.
NOTE 1: Read the instruction manual that came with the IDE hard drive to determine whether the interface card bus type (ISA, EISA, VLB or PCI local bus) is compatible with the host computer.
NOTE 2: Refer to the computer and hard drive user manuals to compare the BIOS requirements of the new hard drive with the computer's BIOS specifications to make sure the new hard drive is compatible.
NOTE 3: If installing a new IDE hard drive controller, refer to the user manual to determine whether the interface card is Windows 95-compatible Plug-and-Play, or a legacy model, which may be jumper selectable.
1) Save all files and close all applications if applicable.
2) Backup using DOS or backup using Windows 95 all desired application programs and data files on the hard drive using a network, tape backup unit, or diskettes if applicable.
3) Turn off the computer and disconnect the power cords.
4) Remove the computer cover.
5) Remove the existing IDE hard drive:
a) Disconnect the power and data cables.
b) Remove the screws holding the hard drive in its drive bay.
c) Slide the hard drive out of the bay and lift it out of the computer.
6) Set the drive selection jumper:
a) If the new hard drive is configured as the only or primary device using the IDE controller, the drive selection jumper should be left at the manufacturer's setting.
b) If the new hard drive is configured as the second of two devices using the IDE controller, the drive selection jumper must be set to 'Slave'.
7) Insert the hard drive unit into an empty 3.5 inch or 5.25 inch bay, and secure the drive in the bay with four screws.
8) Connect the power cable to the drive unit.
9) Connect the internal IDE hard drive unit to the internal IDE adapter connector using the 40 pin ribbon cable.
10) Replace the computer cover, and connect the power cords.
11) If the new hard drive will not be used to boot the computer, turn on the computer, and do the following:
NOTE 1: Properly installed hard drives are auto-detected on IDE controllers during start-up.
NOTE 2: Typical installation errors are wrong jumper selections, loose connections or bad components. If the computer does not start normally, refer the problem to next-level support or a qualified computer technician.
NOTE: The hard drive is now ready to have data restored onto it.
